The Style 85 seal is similar to the P/S®-I seal in that it is a single or multi-lip seal in a single casing. Because each seal is machined, it can be manufactured in various sizes and configurations without special tooling requirements. Style 85 is o-ring mounted, so it can be installed and removed without damage.

The P/S®-II seal is a cartridge mounted, multi-lip seal, which is designed to seal those thick, viscous, temperature-sensitive products that create problems for face seals. The P/S®-II seal is extremely successful sealing positive displacement and centrifugal pumps within the published operating limits. The seal is not recommended in applications where the sealed product contains solids. Simple repair kits available.

The 3-D Seal is designed to be the foremost solution for high radial misalignment and high run out applications. By combining Garlock’s proven P/S®-II and expansion joint technologies into a single solution, Garlock has developed a seal that leads the industry in solving applications plagued with high misalignment and run out. While this seal is typically used on agitators and mixers, Garlock’s wide range of available materials make it possible to configure this seal to fit a virtually endless array of applications in various industries. Each seal is custom designed to your application, allowing Garlock to minimize the difficulty of retrofitting your equipment and through this, increase value and further minimize the total cost of ownership. *Patent Pending

A double seal utilized as the critical seal in a broad range of equipment in the industrial market including industrial fans and autoclaves. The Syntron RP seal has also proven to be highly effective on propeller shafts and thrusters in the marine industry.

A single cartridge mounted face seal with a stationary, balanced design for service in higher pressures and higher speeds than typical unbalanced alternatives. The GMP-I is for use in clean general service and moderate abrasive service. It is available in a wide range of materials to accommodate application requirements. Its balanced design allows it to perform in pressure and vacuum service. Repair kits are available for easy repair.

A double cartridge mounted face seal which is both stationary and balanced, which can be used in higher pressures and at higher speeds than unbalanced alternatives. it can be used with a pressurized barrier fluid (double seal applications) or unpressurized buffer fluid (tandem applications). The GMP-II seal is available in a wide range of materials to suit the application requirements.

The type 35-seal is a heavy duty single spring cartridge seal designed for thick or abrasive slurry service. The large single spring acts as an auger and resists clogging in applications that are difficult for multiple spring seals. Repair kits are available for simple repair. Style 35FS is a unique seal utilizing a P/S-I lip seal as an excluder. The P/S-I fits into the bore of the seal chamber and rides on an extended sleeve. The result is a seal combination that operates in slurries with a minimum of flush water. Repair kits are available for easy repair.

The Style-19 seal is a double concentric face seal designed for mixers and agitators or equipment where radial shaft movement is beyond accepted limits for typical face seals. The Style-19 will accommodate up to 1/8” (03.18MM) of radial shaft movement. Its concentric face design allows it to be mounted to equipment and requires no counterbore for mounting. Because of its stationary design, it will accommodate high speed. This seal requires a barrier or buffer fluid to be used between the inner and outer faces. The Style-19 is available in materials to suit most application requirements.

The Style-20 seal is a single balanced cartridge seal that is (similar to the Style-19), capable of accommodating 1/8” (03.18MM) of radial shaft movement. The Style-20 is a stationary design and can operate at higher speed and pressures than many other alternatives. Because it is a single seal, the faces must be flooded while in service.

The GPA is an ideal seal utilized in a broad range of abrasive applications found in the Mining, Processing and Pulp & Paper industries. With its simple, sturdy, and proven design the GPA can be adapted to almost any industrial pump, mixer or agitator. The GPA is available in a wide range of materials and configurations to suit the specific application requirements.